ABB ACS880-104

404 Parameters
60.60 DDCS controller
ref1 type
Selects the type and scaling of reference 1 received from the
external controller. The resulting value is shown by 03.11
DDCS controller ref 1.
Auto
Auto Type and scaling are chosen automatically according to
which reference chain (see settings Torq ue, Speed,
Frequency) the incoming reference is connected to. If the
reference is not connected to any chain, no scaling is applied
(as with setting Transparent).
0
Transparent No scaling is applied. 1
General Generic reference with a scaling of 100 = 1 (ie. integer and
two decimals).
2
Torque The scaling is defined by parameter 46.03 Torq u e sc al ing .3
Speed The scaling is defined by parameter 46.01 Speed scaling.4
Frequency The scaling is defined by parameter 46.02 Frequency scaling.5
60.61 DDCS controller
ref2 type
Selects the type and scaling of reference 2 received from the
external controller. The resulting value is shown by 03.12
DDCS controller ref 2.
For the selections, see parameter 60.60 DDCS controller ref1
type.
Auto
60.62 DDCS controller
act1 type
Selects the type/source and scaling of actual value ACT1
transmitted to the external controller.
Auto
Auto Type/source and scaling follow the type of reference 1
selected by parameter 60.60 DDCS controller ref1 type. See
the individual settings below for the sources and scalings.
0
Transparent Reserved. 1
General Reserved. 2
Torque 01.10 Motor torque is sent as actual value 1. The scaling is
defined by parameter 46.03 Torque scaling.
3
Speed 01.01 Motor speed used is sent as actual value 1. The scaling
is defined by parameter 46.01 Speed scaling.
4
Frequency 01.06 Output frequency is sent as actual value 1. The scaling
is defined by parameter 46.02 Frequency scaling.
5
60.63 DDCS controller
act2 type
Selects the type/source and scaling of actual value ACT2
transmitted to the external controller.
Auto
Auto Type/source and scaling follow the type of reference 2
selected by parameter 60.61 DDCS controller ref2 type. See
the individual settings below for the sources and scalings.
0
Transparent Reserved. 1
General Reserved. 2
Torque 01.10 Motor torque is sent as actual value 2. The scaling is
defined by parameter 46.03 Torque scaling.
3
Speed 01.01 Motor speed used is sent as actual value 2. The scaling
is defined by parameter 46.01 Speed scaling.
4
Frequency 01.06 Output frequency is sent as actual value 2. The scaling
is defined by parameter 46.02 Frequency scaling.
5
60.64 Mailbox dataset
selection
Selects the pair of data sets used by the mailbox service in
the drive/controller communication.
See section External controller interface (page 75).
Dataset
32/33
Dataset 32/33 Data sets 32 and 33. 0
No. Name/Value Description Def/FbEq16