EasyManua.ls Logo

ABB ACS880-107 Series

ABB ACS880-107 Series
202 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The motor (output) connections for each module are located at the lower part of the cubicle;
depending on the power of the inverter module, these are either detachable or non-detachable
terminal blocks.
The cubicle is equipped with cable entries for the motor cables in the floor.
The picture below presents an example of a 400 mm wide cubicle with three R1i to R4i
modules.
Compartment
doors open
Compartment
doors closed
ExplanationItem
Main DC switch-disconnector handle for
all units in the cubicle
1
Compartments for inverter modules (with
DC switch-disconnector handle)
2
Output connections3
Cable entries4
Common DC fuses for all units in the cu-
bicle
5
Inverter module6
Inverter control unit7
Module-specific DC switch-disconnector
with fuses
8
5
8
8
7
6
7
6
3
2
1
2
2
4
Hardware description 21

Table of Contents

Related product manuals