￭ Installation of I/O extension, fieldbus adapter and pulse encoder
interface modules
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
Pay attention to the free space required by the cabling or terminals coming to the option
modules.
1.
Repeat the steps described in Electrical safety precautions (page 57).
2. Pull out the lock.
Note: The location of the lock depends on the module type.
3. Install the module to a free option module slot on the control unit.
4. Push in the lock.
Electrical installation 83
To Next Page
Loading...
