Info/IllustrationAction
DANGER
Make sure all safety requirements are met
when performing the first test run. These are
further detailed in the section First test run
may cause injury or damage on page 27.
13
Fitting of cylindrical roller bearing
The procedure below details how to fit the cylindrical roller bearings onto the
balancing device shaft and into the frame brackets.
Info/IllustrationAction
Shown in the figure Location
of balancing device on
page 198
Fit the inner ring of the bearing onto both end parts of
the balancing devices shaft.
1
Art. no. is specified in Re-
quired equipment on page 199
Fit the outer ring of the bearing into both brackets with
a press toll, bearing.
2
Part no. is specified in Re-
quired equipment on page 199
Fit the sealing ring with dust lip with the same, but
turned, press tool, bearing.
3
Art. no. and amount specified
in Required equipment on
page 199
Lubricate the bearing and the sealing with grease.4
DANGER
Make sure all safety requirements are met when perform-
ing the first test run. These are further detailed in the
section First test run may cause injury or damage on
page 27.
5
Product manual - IRB 4400 205
3HAC022032-001 Revision: Q
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.6.1 Replacement of balancing device
Continued
To Next Page
Loading...
