7.6 Standard tools
General
All service (repairs, maintenance, and installation) procedures contains lists of
tools required to perform the specified activity.
All special tools required are listed directly in the procedures while all the tools
that are considered standard are gathered in the standard toolkit and defined in
the following table.
This way, the tools required are the sum of the standard toolkit and any tools listed
in the instruction.
Contents, standard toolkit
ToolQty
Allen key 5-17 mm1
Socket with ratchet1
Box spanner set1
Screwdriver1
Torx socket no:20, 25, 301
Extension bar 100 mm1
Puller bar2
KM nut (KM10, KM17)1
Lifting hoist1
Cutting pliers1
Torque wrench 10-470 Nm1
Product manual - IRB 4400 291
3HAC022032-001 Revision: Q
© Copyright 2004-2018 ABB. All rights reserved.
7 Reference information
7.6 Standard tools
To Next Page
Loading...
