4.4.7 Measuring the play, axis 6
General
After reassembly due to repair work or any other reason, the play in axis 5 and 6
must be checked to ensure the repetition accuracy of the robot positioning. The
procedure for axis 6 is detailed below.
Required equipment
NoteArt. no.Equipment
Content is defined in sec-
tion Standard tools on
page 291.
-Standard toolkit
3HAB1611-6Measuring tool, play
3HAB6337-1Measuring tool, play (IRB 4400/L10)
These procedures include
references to the tools re-
quired.
Other tools and procedures may be required.
See references to these procedures in the
step-by-step instructions below.
Additional equipment - Foundry Prime
NoteArt. no.Equipment
Mercasol3HAC034903-001Rust preventive
3HAC026759-001Sikaflex 521FC
12340011-116Loctite 574
Brush
3HAC035355-001Foundry Prime touch up kit
Measurement, axis 6
The procedure below details how to measure the play in axis 6.
Note
The measuring tool and measuring values differ depending on robot version!
InformationAction
DANGER
Turn off all:
• electric power supply
• hydraulic pressure supply
• air pressure supply (do not turn
off for Foundry Prime robots!)
to the robot, before entering the robot
working area.
1
Art. no. is specified in Required equipment
on page 183.
Fit the measuring tool, play to the turning
disk.
2
Continues on next page
Product manual - IRB 4400 183
3HAC022032-001 Revision: Q
© Copyright 2004-2018 ABB. All rights reserved.
4 Repair
4.4.7 Measuring the play, axis 6
To Next Page
Loading...
