48 Mechanical installation
Tilted installation to the wall-mounting plate
You can install the inverter to a tilted surface 10…90 degrees from horizontal.
Do not install the inverter tilted to the front.
1. Lift the inverter from the lifting positions
(a) on the sides of the connection area
and stabilize it from the top.
2. Tilt the inverter back to correspond to
the installation angle.
3. Move the inverter on to the wall-
mounting plate so that the inverter is
slightly above the wall-mounting plate
(b).
4. Lower the inverter into the hook on the
wall-mounting plate (c).
5. Install and tighten the 2 M5x20 (T25)
screws (one on each side) to secure the
inverter to the wall-mounting plate.
6. Use a padlock to prevent unauthorized removal.
7. If it is necessary, remove the eye bolts.
To Next Page
Loading...
