ABB Relion 670 series - Page 129

4. In the “Select GOOSE Block and Signal” dialog window, select needed
GOOSE Input signal from either “GOOSE Receive Blocks In Configuration”
or “New GOOSE Receive Blocks” section.
For more information on the GOOSE Receive blocks, see Section
"User
interface"
5. Click on the “Connect” button, the GOOSE connection will be added to the
configuration as shown in Figure
84 below.
IEC16000177-1-en.vsd
IEC16000177 V1 EN-US
Figure 84: ACT: GOOSE configuration on Receiver IED (left) and
Sender IED (right) side
6. If SCL configuration data attributes needs to be connected the needed data
attributes needs to be selected in the SCL configuration tab (See Figure 76).
6.1. Click on the “Connect” button.
6.2. Select the needed GOOSE input signal in the “Select GOOSE Block
and Signal” dialog window.
6.3. Click on the Connect button.
In this case, GOOSE connection will be added as shown in Figure
85 below.
1MRK 511 398-UEN C Section 8
IEC 61850 communication engineering
670 series 2.2 IEC 123
Engineering manual