IEC09000715 V5 EN-US
Figure 23: PCM600: IED Setup completion wizard
It is not possible to go back and do any modifications in the setup
complete page. If an error is detected, the insertion has to be
canceled and the IED has to be inserted again.
When the online configuration is completed, it is advised to read
the configuration from the IED to ensure that the IED object in
PCM600 has the same configuration data as the physical IED.
Inserting an IED from the template library
An IED in the plant structure can be exported as a template (*.pcmt). The user can
build up a template library with all the exported IED templates. It is possible to
insert an IED from the template library to create a new IED in the plant structure.
Change the IP address and the name that corresponds to the physical IED after a
template IED has been imported.
A template IED can only be inserted when the bay is selected in the
plant structure.
Procedure to insert a template IED
1. Right-click the Bay in the plant structure.
1MRK 511 398-UEN C Section 4
Setting up a project
670 series 2.2 IEC 53
Engineering manual
To Next Page
Loading...
