Abus AZWG10020 - Page 138

62 UK
telephone.
 0 ends the recording
Enter contact telephone numbers 1–
10
*7
 Then press the digit for the
corresponding number of the
contact (1=1.0=10)
 Enter the corresponding
telephone number, followed
by #.
 Enter the telephone number
a second time to confirm,
also followed by #.
Note:
If the two inputs are the same, you
hear a high confirmation beep.
If the two inputs are not the same,
you hear a low error beep.
Example:
Telephone number 1234567 for
contact 3
*73 1234567# 1234567#
Test of sending of the voice alarm
messages A–H or the text alarm
messages A–H
Calls are placed after
remote access mode ends
*8
 Then press the digit for the
corresponding message
(1=A, 8=H)
 The device ends remote
access mode and calls all
programmed numbers of this
alarm message (contact
type voice) or sends an SMS
alarm message to all
programmed numbers
(contact type text).
Restore voice messages
Restore text messages
Sending of these messages cannot be
tested in remote access mode. Use
the “Test Messages” option on the
device to do this.
Play memo
0
 Pressing 0 again ends
playback