Inserting SD cards
Inserting an SD card in the B6 makes the following possible.
• Loops can be saved and loop recording time increased.
• Impulse response data, including data you already have and from third parties, can be loaded and used.
• The B6 can be used as a card reader.
• The firmware can be updated.
1. When the power is off, open the SD card slot cover, and insert an SD card all the way into the slot.
To remove an SD card, push it further into the slot and then pull it out.
NOTE
• Cards that conform to SD, SDHC or SDXC specifications are supported.
• Disable write-protection on the SD card before inserting it.
• Inserting or removing an SD card while the power is on could result in data loss.
• When inserting an SD card, be sure to insert the correct end with the top side up.
• Before using SD cards that have just been purchased or that have been formatted on a computer, they
must be formatted by the B6 (→ Formatting SD cards).
24
To Next Page
Loading...
Need help?
General