Setting the looper
Various looper settings can be made.
Setting the recording time
The length of the recorded loop can be set.
1. Turn or drag the TIME knob up or down on the Looper Control Screen (→ Using the looper while
playing)
Setting Explanation
MANUAL Recording will continue until stopped manually or the maximum recording time
is reached.
♩×1–64
This sets the value to 1–64 quarter notes. The actual recording time depends on
the BPM (tempo) setting (→ Adjusting the master tempo)
Recording time (seconds) = 60 ÷ BPM × number of quarter notes
When the set recording time is reached, recording will stop and loop playback
will start.
NOTE
• The setting options include MANUAL and 1–64 quarter notes.
• The recording time for the looper is 2–45 seconds when stereo and 2–90 seconds when mono. To switch
between stereo and mono, see Setting to stereo or mono
• Settings that would exceed the maximum recording time will be adjusted automatically.
• Changing the recording time will delete the recorded data.
49
To Next Page
Loading...
Need help?
General