Loading impulse response (IR) data
You can load your own impulse response data and impulse response data from third parties.
NOTE
Impulse response data in the following format can be loaded.
• Format: WAV
• Sampling frequency: 44.1–192 kHz
1. Copy impulse response data to an SD card.
Copy impulse response data to the “B6_IR” folder on the SD card. (→ B6 folder and file structure)
The “B6_IR” folder is created at the top level of an SD card when it is formatted by the B6. (→
Formatting SD cards)
2. Insert the SD card (→ Inserting SD cards)
3. Touch on the Menu Screen.
4. Touch for the location where it will be assigned.
Impulse response data is already assigned to locations 001–036. You can assign impulse response
data as you like to 037–120.
5. Touch the impulse response data that was assigned.
109
To Next Page
Loading...