ADCMT 6146 User Manual

6146/6156 DC Voltage/Current Generators Operation Manual
5.8.4 6144-compatible Remote Command List
5-42
5.8.4 6144-compatible Remote Command List
The following table shows commands compatible with the former model 6144.
All there commands are available whether or not in the compatible mode unless otherwise states.
To optimize the 6146/6156 capabilities, using the normal commands is recommended unless a particular
emphasis on the compatibility is placed.
Refer to Section 5.1.2 "Compatibility."
Class Item Command Description
Default Operation
Power ON
Factory
shipment
Memory Sweep
Source
Output E Output ON (Operate)
H Output OFF (Standby)
E?
H?
Query of the output status
Response:
Operate: E
Standby: H
Suspend: H
Function /range V2 Voltage source 30 mV
V3 Voltage source 300 mV
V4 Voltage source 3 V
V5 Voltage source 30 V
V6 Voltage source 30 V (Same function as V5)
I1 Current source 3 mA
I2 Current source 30 mA
I3 Current source 200 mA
V?
I?
Query of the function /range
Response: V2 to V5, 11 to 13
Voltage/current
source value
D±data [unit]
Voltage/current source value setting:
*1
D
±ddddd: fixed range
D
±dddddunit: auto range (NRF available)
Unit V: volt
MV: millivolt
UV: microvolt
MA: miliampere
UA: microampere
Example when setting -1.5 mV
D-1.5 (Set V2 or V3 in advance.)
Example when setting +1.5 V
D1.5 (Set V4, V5 or V6 in advance.)
D1.5V
• The source value cannot be set during thermal
EMF output.
• This command is not affected by auto range
OFF/ON (SVRXn/SIRXn).
0
D?
Query of the source value :
*2
Response:
DV±ddddE±d
DI±ddddE±d
*1: The setting range of the source value varies depending on the model, range or function. For more information, refer to Chapter 8, "SPEC-
IFICATIONS."
*2: The number of digit and the position of the decimal point vary depending on the model, range or function. For more information, refer to
Section 5.7, "Source Value Output Format (Talker Format)."

ADCMT 6146 Specifications

General

Brand	ADCMT
Model	6146
Category	Portable Generator
Language	English