Adtech iMASTER – A1 Series - Run Command Source to Run; Stop Keys on Keypad; Run Command Source to Input Terminal

A1-User’s Manual
５５
7.6 Run Command Source to Run / Stop Keys on Keypad
 Diagram
 Programming A1 Parameters
 Diagram
 Programming A1 Parameters
 On Keypad, program following parameters with corresponding values:
Code
Set Value
Description
20.02
9
Run Command Source to RUN / STOP Keys on
Keypad
7.7 Run Command Source to Input Terminal
 Diagram
 Programming A1 Parameters
 Diagram
 Programming Run Command Source
 On Keypad, program following parameters with corresponding values
Code
Set
Value
Description
20.02
3
Run Command Source to Input Terminal
(2 Wire 2, Refer to ‘8.2.9 Start/Stop/Direction)
CM 6 5 4 3 2 1
FWDREV
RUN/ STOP key