AEM TESTPRO CV100 - Network Autotest Procedures

42
WWW.AEM
-
TEST.COM
customercare@aem-test.com | Version # : 2.2
TestPro CV100
User Manual
•
•
•
Select[Tools].
Select[SignalStrength].
The [Signal Strength] screen will display the SSID,
current dBm value, IP address, channel indicator and
signal indicator.
c.NetworkAutotest
i.SelectingTestLimit
Select[Project]onthehomescreentochooseanactive
test project.
Select [Edit test prole] to select or update the test
prole.
Select[Limit].
[Network Discovery Mode] and [Network Discovery
Time] are set to [Time Bound] and 30 seconds by
default.
•
•
•
•
Note: In Full Discovery mode, TestPro will scan the
entire network. After network discovery scanning,
Autotestwillcontinuewithothertests.In[TimeBound]
mode,TestProwillscanthenetworkfor thespecied
duration.
Refer to 2e i .select cable/connector section
ii.SelectingCable/Connector
To perform a Network Autotest, the WI-FI dongle must
be connected to the WI-FI access point or the Ethernet
cable must be connected to a LAN port - either the side
port of the tester or the ADNET adapter MUlti-Gig port.
iii. Performing Network Autotest
•
•
•
•
•
Select[NetworkTestandCloud].
Select[NetworkTest].
Select[Autotest].
Autotest will commence.
To view the measurement results select the required
parameteri.e.,[DeviceAddresses].AlistofdiscoveredIP
& media access control (MAC) addresses will be shown.
iv. Saving Network Autotest