AEQ FORUM
Digital audio mixer for broadcast applications
67
• “Default Routing”: allows you to configure the signal routed by default to that output
channel. You can select any input channel (“Inputs” in “Type” column) or any of the
internal summing buses (“Mixer” in “Type” column; see section 4.2.2 of this manual).
• “Mono”: allows you to configure the logical output channel as Mono or Stereo. By
default, all the outputs channels of AEQ FORUM are defined as Stereo. If any channel
is re-configured to Mono it will result in an incremented number of the listed available
output channels: one Stereo Channel is converted into two Mono channels.
4.2.4. “Monitoring Configuration “ submenu.
“Monitoring Configuration” submenu is accessed, from the drop-down menu “Hardware
Configuration”, by clicking on the icon:
“Monitoring Configuration” submenu allows you to define the operation of the Control and
Monitoring sections associated with the control room and the studio room. Please refer to
sections 2.1.2.4 and 2.1.2.5 of this manual.
To Next Page
Loading...
Need help?
General