4904 1 Adjusts the ADS lower limit.
4905* ADS Area Select [0 = All / 1 = One]
4905 1
Checks the whole area (0 = All) or the area between 15 mm and 90 mm from the left edge
(1 = One) to adjust the ADS level.
4921* Image Adj Selection
4921 1
Image Adj Selection (Copy) [0 to 10 / 0 / 1]
Selects which mode the settings from SP 4922 to SP 4932 and are used for:
0 = None, 1 = Text 1, 2 =Text 2, 3= Photo 1, 4 = Photo 2, 5 = Photo 3, 6 = Special 1, 7
= Special 2, 8 = Special 3, 9 = Special 4, 10 = Special 5
4922*
Scanner Gamma
Selects "text" or "photo" as the priority output mode. This setting is applied to all image
processing modes of SP 4921.
4922 1 Scanner Gamma (Copy) [0=System default/1=Text/2=Photo]
4923*
Notch Selection
Selects the value of the center ID adjustment notch for the ID adjustment LEDs.
Normally the center notch is 3 (range 1-5). If –1 is selected, each notch shifts down
(becomes lighter). If +1 is selected, each notch shifts up (becomes darker).
This setting is applied to all image processing modes of SP 4921.
4923 1 Notch Selection (Copy) [–1 = Light / 0 = Normal / +1 = Dark]
4926*
Texture Removal
Adjusts the texture removal level that is used with error diffusion. 0: The default value for
each mode is used. Text 1, Photo 2, Special 2, and Special 5 have a default of 3 and
Photo 1, 3 have a default of 1.
1: No removal applied.
2 – 5: Removal applied at the level specified here. The higher the setting (level), the less
clear the image will become (more texture removal). This setting is only applied to the
originals in SP 4921.
4. Appendix: SP Mode Tables
42
To Next Page
Loading...
