AGFA CR 10-X Service Manual

DD+DIS155
.11E
Repair and Service
Troubleshooting
DOCUMENT CONTROL NOTE:
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
3 No Error Code - Status LED is off or slow red blinking
Symptom
 No error displayed in the Error Viewer on the workstation
 Status LED is off or slow red blinking (0,6 seconds off, 0,6 seconds on)
 "Digitizer start-up" message is not shown approximately 40 seconds
after switch on.
Background: The digitizer is not able to perform the hardware selftest (boards,
motors, sensors) which is executed approx. 40 seconds after switch-on.
For a default boot-up sequence refer to the digitizer service manual chapter 2,
Functional Description.
Cause 1
Power supply defective.
Solution 1
Check green LED on the external power supply or 24 V output.
If green LED is off or 24 V output not available: Exchange the power supply.
NOTE:
Depending on the power supply version, the 24 V output are available at 6 or 8 pins.
One half of the pins has positive polarity, the other half has negative polarity.
Cause 2
Power board defective.
Solution 2
Check the status of the LEDs on the PMI board indicating that power is available:
If one or more of following LEDs does not light up green, exchange the Power Board:
LD1, LD3, LD5, LD7, LD9, LD10, LD11, LD12, LD13, LD16
See chapter 3.4, Electrical and mechanical Codes, Fuses, LEDs for the location and
meaning of the LEDs.
Cause 3
PMI board defective.
Solution 3
Exchange the PMI board
Edition 1, Revision 2 CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 3.3 / 6 of 46
03-2013 Type 5151 / 100 / 110 / 200 / 210 Agfa Company Confidential

AGFA CR 10-X Specifications

General

Brand	AGFA
Model	CR 10-X
Category	Medical Equipment
Language	English