Name: AGFA CR 10-X
Brand: AGFA
Rating: 4 (1 reviews)

To Next Page

To Previous Page

DD+DIS155

.11E

Controls, Connections, and Setup Procedures

DOCUMENT CONTROL NOTE:

The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.

Edition 1, Revision 4 CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 1 / Page 3 of 47

03-2013 Type 5151 / 100 / 110 / 200 / 210 Agfa Company Confidential

LIST OF CONTENTS

1 INTRODUCTION ......................................................................................................................4

2 INSTALLATION PREPARATION .............................................................................................4

2.1 Checking Installation Site Prerequisites ...................................................................................5

2.2 Unpacking the Digitizer .............................................................................................................5

2.3 Unpacking the NX Workstation and Monitor.............................................................................6

2.4 Checking the Shipment Completeness.....................................................................................6

3 PERFORMING THE INSTALLATION STEPS AS DESCRIBED IN THE QUICK

INSTALLATION GUIDE............................................................................................................7

4 FINALIZING THE INSTALLATION .........................................................................................10

4.1 Adding Windows and NX Users..............................................................................................11

4.2 If required: Configuring Digitizer and NX for the local Network ..............................................15

4.3 Setup of Connectivity to additional System Components.......................................................17

4.4 Customizing System Components according to Customer Preferences................................17

4.5 Finalizing the Workstation Installation ....................................................................................17

4.6 Checking Software Version.....................................................................................................18

4.7 Performing further Activities depending on local Regulations ................................................18

4.8 Customer Training ..................................................................................................................18

4.8.1 Training for Operating the Digitizer.........................................................................................19

4.8.2 Training for Usage of Plates and Cassettes ...........................................................................20

5 APPENDIX: INSTALLATION OF THE DIGITIZER WITHOUT USING THE CR 10-X / CR 12-

X CONFIGURATION WIZARD ...............................................................................................21

5.1 Installation Preparation ...........................................................................................................22

5.2 Connecting the Cables............................................................................................................22

5.3 Performing Setup of the NX Workstation................................................................................23

5.4 Verifying the Installation..........................................................................................................43

5.5 Performing the Installation Wizard of the Digitizer..................................................................45

5.6 Performing a Backup ..............................................................................................................46

5.7 Finalizing the Installation.........................................................................................................46

6 INSTALLATION CHECKLIST .................................................................................................47

AGFA CR 10-X Service Manual

Other manuals for AGFA CR 10-X