AGFA CR 10-X Service Manual

DD+DIS155.11E
Controls, Connections, and Setup Procedures
DOCUMENT CONTROL NOTE:
The controlled version of this document is available from the Agfa HealthCare Library. Any printed copy of this document is uncontrolled.
Edition 1, Revision 4 CR 10-X / CR Reader / CR 12-X / CR Advanced Reader Chapter 1 / Page 47 of 47
03-2013 Type 5151 / 100 / 110 / 200 / 210 Agfa Company Confidential
6 Installation Checklist
# Step Reference Okay Task
code*
Installation Prerequisites
1.
Check installation site prerequisites.
2.1
PRI
2.
Unpack digitizer.
2.2
INS
3.
Unpack NX workstation and monitor
2.3
INS
4.
Check shipment completeness.
2.4
INS
Performing The steps as described in the Quick Installation Guide
5.
Perform the steps as described in the Quick
Installation Guide.
3
INS
Finalizing the Installation
6. Adding Windows and NX users. 4.1
ASC
7.
If required: Configuring Digitizer and NX for the
local Network
4.2
ASC
8.
Setup of Connectivity to additional System
Components
4.3
ASC
9.
Customizing System Components according to
Customer Preferences
4.4
ASC
10. Finalizing the Workstation Installation 4.5
ASC
11. Check digitizer software version 4.6
ASC
12.
Performing further Activities depending on local
Regulations
4.7
ASC
13. Customer Training 4.8
ATR
* Task Code, only applicable for Agfa employees
PRI = Pre-Installation
Ins = Installation task
ATR = Customer training
ASC = Configuration & Customization

AGFA CR 10-X Specifications

General

Brand	AGFA
Model	CR 10-X
Category	Medical Equipment
Language	English