DD+DIS238.06E
Generic Safety Directions
DOCUMENT CONTROL NOTE:
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 3 Generic Safety Directions for HealthCare Imaging Products Page 23 of 28
Ground potential differences:
CAUTION:
To comply with ISO 60601-1 (annex I) all computers and peripherals must be
connected to the same power source.
INSTRUCTION:
• Always connect the associated monitor to the same Uninterruptible Power Source as
the PC.
• When different combinations of equipment are used in various medical environments
a potential difference (V) can exist between the protective earths in different localities.
If the protective earthing fails this potential difference can cause a HAZARD for the
OPERATOR or for the PATIENT.
19 Safety Directions for Maintenance and Repair Activities
• This Technical Documentation identifies the parts on which preventive inspection and
maintenance shall be performed by Agfa HealthCare service personnel, including the
periods to be applied.
• In general the device has to be switched off during service activities. Exception: If the
device is switched on to perform tests pay particular attention to any hazards due to
moving and rotating parts. Avoid lose clothing or finger traps. Switch off the device
immediately after the tests.
• Do not turn motors manually. If required, first disconnect the motor from the motor
control board.
• Make sure that the power cord does not show any signs of damage.
• After repair work always check that the integrated safety features are not overridden
or disconnected.
• If there is any visible damage to the machine casing do not hand-over the product to
the customer. First repair the machine casing.
07-2009 Agfa Company Confidential
To Next Page
Loading...
Need help?
General
