1260 Infinity Binary Pump User Manual 137
Test Functions and Calibration
8
Leak Rate Test
Leak Rate Test
Introduction
The Leak Rate Test is used for verifying the internal tightness of the pump
and helps identifying parts which may have caused a leak.
System requirements
Minimum software revisions:
• Lab Advisor B.02.03
Minimum firmware revisions:
• A.06.50
This test does not work in emulation mode, that is when the G1312B Binary Pump emulates
the G1312A Binary Pump. In case of an emulated module, convert to the original type first
(see “Replacing Module Firmware” on page 181).
To Next Page
Loading...
