Agilent Technologies 1260 Infinity User Manual

1260 Infinity Binary Pump User Manual 65
Using the Pump
4
Setting up the Agilent 1260 Infinity Binary Pump G1312B with the Instrument Control Interface
Pump Control
The pump can be switched between following states: On, Off or to Standby.
In Standby, the pump motor is still controlled. When the pump is switched
on from standby, it does not re- initialize.
The optional seal wash pump can be controlled by either switching it off,
using it for a single time or specifying frequency and duration of periodic
wash intervals.
CAUTION
Upon initialization, the pump ignores the Maximum Flow Gradient value.
This can result in a rapid and uncontrolled pressure increase.
➔ To prevent harm to the column, open the purge valve until the initialization is
finished.

Agilent Technologies 1260 Infinity Specifications

General

Brand	Agilent Technologies
Model	1260 Infinity
Category	Laboratory Equipment
Language	English