1290 Infinity II High-Speed Pumps User Manual 267
12 LAN Configuration
Initialization mode selection
Initialization mode selection
The following initialization (init) modes are selectable:
Using Stored
When initialization mode Using Stored is selected, the parameters are taken from
the non-volatile memory of the module. The TCP/IP connection will be
established using these parameters. The parameters were configured previously
by one of the described methods.
Figure 29 Using Stored (Principle)
Table 26 Initialization Mode Switches
SW 6 SW 7 SW 8 Init Mode
OFF ON OFF Using Stored
OFFONONUsing Default
ON OFF OFF
DHCP
1
1
Requires firmware B.06.40 or above. Modules without LAN on board, see G1369C LAN Interface Card
Non-Volatile
RAM
Stored
Parameter
Active
Parameter
To Next Page
Loading...
