Installation 3
Agilent 5517B/BL/C/D/DL/FL User’s Guide 17
Warranty Claims
Contact the nearest Agilent Sales Office (see list on the Service and
Support page at the end of this manual) for information relative to
warranty claims.
Installing the Laser Head
This section includes details about connecting the laser heads to the power
supplies, axis boards and chassis/systems using the laser head cables. It
also shows how receivers are connected to the axis boards in general, but
does not cover the various models of receivers and receiver cables. Layouts
of typical systems showing the laser head and the inclusion of optics and
interferometers are included, but details about how to set them up are
not.
For details about other system considerations, refer to the Laser and
Optics User’s Manual. An example of the subjects covered in the Laser and
Optics User’s Manual are:
• System design considerations
• System installation and alignment
• Mounting hardware
• Principles of system operation
• Accuracy and repeatability
• Wavelength of light compensation
• Material expansion coefficients
• Beam- directing optics
• Interferometers
• Receivers
• Cables
For details about specific products, refer to their separate manuals.
Visit the Agilent web site for lasers at www.agilent.com/find/lasers for a
complete selection of products, literature and manuals.
To Next Page
Loading...
