54 Operation Manual
3 Operating in Electron Impact (EI) Mode
To Set Monitors for Temperature and Vacuum Status
5 In the Available Monitors column, select MS TOF Vac and click
the Add button to move the selection to the Selected Monitors
column.
6 In the Available Monitors column, select MS Quad Temp and
click the Add button to move the selection to the Selected
Monitors column.
7 In the Available Monitors column, select MS Source Temp and
click the Add button to move the selection to the Selected
Monitors column.
8 Select any other monitors you want and add them to the
Selected Monitors column.
9 Click OK. The new monitors will be stacked on top of each
other in the lower right corner of the Instrument Control
window.
10 Select Window > Arrange Plots and Monitors, or click and drag
each monitor to the desired position. See Figure 12 for one
way of arranging the monitors.
11 To make the new settings part of the method, select Save from
the Method menu.
Figure 12 Arranging monitors
To Next Page
Loading...
