To Next Page

To Previous Page

ESG-D Series Option H98 Signal Generators In–Channel, Base Station and Mobile Receiver Testing

Reconciling New Firmware Revisions with Earlier Revisions

Manual Supplement 1-7

Reconciling New Firmware Revisions

with Earlier Revisions

Remote and front-panel operation of ﬁrmware revision B.02.30 and greater is quite

different from earlier ﬁrmware revisions. This section documents the remote operation

commands from earlier ﬁrmware revisions that are still valid in revision B.02.30.

To determine the ﬁrmware revision of your instrument, press

Utility > Instrument Info/Help

Mode

> Diagnostic Info. To locate the ﬁrmware revision information on the display, see the

following illustration.

Remote Operation

The following SCPI commands were used in previous versions of ﬁrmware. Although they

are different than the commands for the current ﬁrmware, they can still be used.

System Frame Number Query

This command query retrieves the current value of System Frame Number from the

wideband CDMA hardware.

[:SOURce]:RADio:WCDMa[:BBG]:SFN?

Wideband CDMA Off On

This command sets the wideband CDMA modulation operating state to on or off. The

command query will retrieve wideband CDMA operating state information from the signal

generator.

[:SOURce]:RADio:WCDMa[:BBG][:STATe] ON|OFF|1|0

[:SOURce]:RADio:WCDMa[:BBG][:STATe]?

Firmware Revision Number

Agilent Technologies ESG-D Series Manual Supplement

Other manuals for Agilent Technologies ESG-D Series