Softkey Reference ESG-D Series Option H98 Signal Generators
Wideband CDMA Softkeys
4-34 Manual Supplement
Uplink Power
Press this softkey to set the power level of the uplink channels 2 and 3
relative to uplink channel 1.
Softkey Location:Mode>Wideband CDMA>Channel Setup>Uplink Power
Range:±30 dB of the uplink channel 1 power level
Status after Normal Preset: 0.00 dB
SCPI Command and Command Query:
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel2|3:POWer <value>
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel2|3:POWer?
Uplink Trig Delay
Press this softkey to change the propagation delay timing between the
trigger from the base station and the RF output of the instrument. To
enter the uplink trigger delay value, rotate the front-panel knob until
the desired value is displayed, use the up and down arrow keys, or
enter the value using the numeric keypad and press the
Enter
terminator softkey. For additional information, see“Understanding
Time Offsets”on page 3-8.
Softkey Location:Mode>Wideband CDMA>Channel Setup>Uplink Trig Delay
Range:−50 to +204 chips
Status after Normal Preset: 0 chips
SCPI Command and Command Query:
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:TRIGger:DELAy <value>
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:TRIGger:DELAy?
To Next Page
Loading...
