Softkey Reference ESG-D Series Option H98 Signal Generators
Wideband CDMA Softkeys
4-16 Manual Supplement
Multiplex
Press this softkey to select a data insertion point prior to multiplex.
When
Multiplex is chosen, the selected data pattern is segmented directly
into timeslots with Pilot and TPC symbols but without CRC,
convolution, or interleaving. Filler bits consisting of 0’s are inserted in
place of the bits normally produced by convolutional coding.
Softkey Location:
Mode > Wideband CDMA > Channel Setup > More (1 of 2) >
Data Insertion > Multiplex
SCPI Commands and Command Queries:
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:DATA:
INsert MULTiplex
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:DATA:
INsert?
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:DATA:
INsert MULTiplex
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:DATA:
INsert?
Perch Setup
Press this softkey to display the Perch Setup menu which enables you
to set the operating state of the Perch1 and Perch2 channels, and define
the BCCH setup.
Softkey Location:
Mode > Wideband CDMA > Perch Setup
Perch1 Off On
Press this softkey to toggle the operating state of the Perch1 logical
channel for synchronization. The Perch1 channel can be enabled alone,
with any combination of the Perch2 channel and channel 1, or it can be
turned off. A short code of C8(0) is automatically assigned to the Perch1
channel. The
W-CDMA Off On softkey must be enabled in order for this
signal to be generated. The
Perch1 Off On softkey is only displayed when
the
Link Down Up softkey is selected to the downlink direction.
To Next Page
Loading...
Need help?
General
