Agilent Technologies ESG-D Series Manual Supplement

Programming Information ESG-D Series Option H98 Signal Generators
Wideband CDMA Subsystem SCPI Command Reference
5-14 Manual Supplement
Downlink Channel Power
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:POWer <value>
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:POWer?
Execute this command to set the downlink channel’s power relative to the power of the
Perch1 and Perch2 channels.
Range:
±30 dB of Perch1 and Perch2 power setting
Status after *RST: 0.00 dB
Downlink Long Code
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:LCODe <value>
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:LCODe?
Execute this command to assign a specific long code to the Perch channels and the
dedicated traffic channel when the signal generator is in downlink mode.
Range: 1 to 128
Status after *RST: 1
Interrupt Trigger
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:INTerrupt:TRIGger
Execute this command to interrupt downlink channel 1. Channel 1 is interrupted for the
duration specified by the interrupt value. Executing this command is equivalent to turning
the channels off for the duration of the interrupt value and then back on. This command
may only be executed while the signal generator is in downlink mode.
Interrupt Time
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:INTerrupt[:TIMe] <value>
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:INTerrupt[:TIMe]?
Execute this command to change the time duration that the Interrupt Trigger will
interrupt downlink channel 1. This command may only be executed while the signal
generator is in downlink mode.
Range:
0.020 to 10.00 seconds, in 20 millisecond steps
Status after *RST: 1.000 second

Agilent Technologies ESG-D Series Specifications

General

Brand	Agilent Technologies
Model	ESG-D Series
Category	Portable Generator
Language	English