To Next Page

To Previous Page

Softkey Reference ESG-D Series Option H98 Signal Generators

Wideband CDMA Softkeys

4-24 Manual Supplement

Short Code (Channels 2 and 3)

Press this softkey to set the short code for uplink channels 2 or 3. To

enter the short code value, rotate the front-panel knob until the desired

value is displayed, use the up and down arrow keys, or enter the value

using the numeric keypad and press the

Enter terminator softkey. This

short code value is used for uplink channels 2 and 3, except in

multicode mode during the Pilot and TPC symbols, when the primary

channel short code value is used.

The range of values for channels 2 and 3 short code are coupled to their

symbol rates, as previously described for Short Code (Channel 1).

Softkey Location:

Mode > Wideband CDMA > Channel Setup > Short Code

Range: See Table 4-3

Status after Normal Preset: 9 (channel 2)

10 (channel 3)

SCPI Command and Command Query:

[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel2|3:SCODe <value>

[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel2|3:SCODe?

Spread

Press this softkey to select spread data insertion. When Spread is

chosen, the selected data pattern is spread directly without

segmentation.

Softkey Location:

Mode > Wideband CDMA > Channel Setup > More (1 of 2) >

Data Insertion > Spread

SCPI Commands and Command Queries:

[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:DATA:

INsert SPREad

[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:DATA:

INsert?

[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:DATA:

INsert SPREad

[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:DATA:

INsert?

Agilent Technologies ESG-D Series Manual Supplement

Other manuals for Agilent Technologies ESG-D Series