Agilent Technologies ESG-D Series - Upch; Uplink Mode Chan Multicode

Softkey Reference ESG-D Series Option H98 Signal Generators
Wideband CDMA Softkeys
4-32 Manual Supplement
UPCH
Press this softkey to change the uplink/downlink channel or multicode
type to a User Packet Traffic Channel (UPCH).
Softkey Location: Mode > Wideband CDMA > Channel Setup > Channel Type >
UPCH
Or: Mode > Wideband CDMA > Channel Setup > Multicode Type > UPCH
SCPI Commands and Command Queries:
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:TYPE UPCH
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:TYPE?
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:TYPE UPCH
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:TYPE?
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:MCOD[1]:TYPE UPCH
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:MCOD[1]:TYPE?
Uplink Mode Chan Multicode
Press this softkey to toggle the uplink operating mode between channel
and multicode mode.
Chan Selects channel as the uplink transmission mode.
In channel mode, three uplink channels are available.
Channel 1 includes the following selectable
parameters:
• operating state,
• channel type,
• symbol rate,
• short code,
• data pattern,
• long code,
• data insertion,
• transmission power control,
• time offset adjustments (TSector, TFrame, TSlot),
• uplink trigger delay, and
• phase polarity.