ESG-D Series Option H98 Signal Generators Programming Information
Wideband CDMA Subsystem SCPI Command Reference
Manual Supplement 5-17
Pilot-TPC Power
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:MCOD:NPOWer <value>
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:MCOD:NPOWer?
Execute this command to set the pilot-TPC power level for the active multicode.
Range:
1 to 3
Status after *RST: 1
SFN Fixed Value
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:PERCh[1]:SFNumber[:TYPE]:FIX <value>
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:PERCh[1]:SFNumber[:TYPE]:FIX?
Execute this command to select the value for a fixed System Frame Number. Only even
numbered values are allowed.
Range: 0000 to 0FFE (hexadecimal, evens only)
Status after *RST: 0000 (hexadecimal)
Short Code (Channel 1)
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:SCODe <value>
[:SOURce]:RADio:WCDMa[:BBG]:DLINK:CHANnel[1]:SCODe?
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:SCODe <value>
[:SOURce]:RADio:WCDMa[:BBG]:ULINK:CHANnel[1]:SCODe?
Execute this command to set the short code for channel 1. The range of values allowed
depends on the symbol rate, as shown in Table 5-3.
If the symbol rate is changed to a new value, and the short code value does not fall into the
allowed short code range for the new symbol rate value, the short code value is
automatically set to the maximum short code value that corresponds to the new rate.
Status after *RST: 1
Table 5-3 Symbol Rate Versus Channel 1 Short Code Range
Symbol Rate Short Code Range
32 ksps 0 to 127
64 ksps 0 to 63
64 ksps voice 0 to 63
128 ksps 0 to 31
256 ksps 0 to 15
To Next Page
Loading...
Need help?
General
