Agilent Technologies G8610A - Section 7. Maintenance Screen; Maintenance Menu

113
Agilent Technologies Helium Leak Detector
DRAFT 12/11/17
Section 7. Maintenance Screen
7.4 Maintenance Menu
The Maintenance Menu allows you to view or change the settings/parameters of the leak
detector, including
❑ General
❑ Internal Calibrated Leak
❑ Manual Tuning
❑ Spectrometer tuning parameters
❑ Valve Control
❑ Valve status
❑ Pump
❑ Primary/Roughing Pump configuration
❑ Gauge
❑ Test Port TC calibration
❑ System Defaults
❑ Reset Turbo & Filament hours
This Maintenance menu (General) allows you to view and input the value and parameters of
the installed internal calibrated leak. A Software Update utility is also now available.
Figure 7-1 Maintenance General
Access the Software
Internal Calibrated
Leak setup.
Update screen.