Agilent Technologies G8610A

Agilent Technologies Helium Leak Detector
DRAFT 12/11/17
141
7. Configure the following settings:
❑ Bits per second (baud rate) – 9600
❑ Data bits: – 8
❑ Parity: – None
❑ Stop bits: – 1
❑ Flow Control: – None
8. Click OK.
9. Select Properties from the File menu.
The Properties window appears.
10. Configure the following settings on the Connect To tab:
❑ Connect using – Verify the COM port is correct.
❑ Click Configure and verify the port settings are correct.
11. Ensure that the Settings tab is configured as follows:
❑ Terminal keys radio button selected.
❑ Ctrl+H radio button selected.
❑ Auto detect selected from the Emulation pull-down list.
❑ ANSI entered in the Telnet terminal ID.
❑ 500 set in the Background buffer lines field.
12. Click ASCII Set-Up.
The ASCII Set-Up dialog box appears.
13. Ensure that the settings are as follows:
❑ Line delay – 0 milliseconds
❑ Character delay – 0 milliseconds
❑ ASCII Receiving – Wrap lines that exceed terminal width
The cursor begins blinking.
14. Type some simple commands:
❑ ?LEAK
❑ ?ALL
❑ ?SETUP