Agilent Technologies Infinity II 1290 User Manual

Agilent 1290 Infinity II Flexible Pump User Manual 195
LAN Configuration
11
Initialization Mode Selection
Using Stored
When initialization mode Using Stored is selected, the parameters are taken
from the non- volatile memory of the module. The TCP/IP connection will
be established using these parameters. The parameters were configured
previously by one of the described methods.
Figure 28 Using Stored (Principle)
Using Default
When Using Default is selected, the factory default parameters are taken
instead. These parameters enable a TCP/IP connection to the LAN
interface without further configuration, see Table 12 on page 195.
Figure 29 Using Default (Principle)
Cdc"KdaVi^aZ
G6B
HidgZY
EVgVbZiZg
6Xi^kZ
EVgVbZiZg
6Xi^kZ
EVgVbZiZg
9Z[Vjai
EVgVbZiZg
NOTE
Using the default address in your local area network may result in network problems. Take
care and change it to a valid address immediately.
Tabl e 12 Using Default Parameters
IP address: 192.168.254.11
Subnet Mask: 255.255.255.0
Default Gateway not specified

Agilent Technologies Infinity II 1290 Specifications

General

Brand	Agilent Technologies
Model	Infinity II 1290
Category	Water Pump
Language	English