10 Agilent SPS 4 Autosampler User’s Guide
1 Safety Practices and Hazards
Always ensure that laboratory safety practices governing the use, handling
and disposal of such materials are strictly observed. These safety practices
should include the wearing of appropriate safety clothing and safety
glasses.
Components of the autosampler move automatically and at speed.
Safety Symbols
The general definitions of safety symbols used on equipment or in
manuals are listed below.
Direct current.
On supply.
Off supply.
Hazardous voltage and potential for electrical shock. Do not touch
terminals that have this symbol when the equipment is on.
Caution, refer to accompanying documentation. Equipment marked with
this symbol indicates that it is necessary for the user to refer to the
instruction manual.
The CE mark shows that the product complies with all applicable
European Directives.
The CSA mark is a registered trademark of the Canadian Standards
Association.
WARNING
Keep clear of the probe arm assembly during operation to prevent injury.
NOTE
A protective cover is available to prevent accidental contact with the probe arm assembly.
Contact your local Agilent representative for further information.
^
To Next Page
Need help?
General
