12 Agilent SPS 4 Autosampler User’s Guide
1 Safety Practices and Hazards
CE Compliance
Your autosampler has been designed to comply with the requirements of
the Electromagnetic Compatibility (EMC) Directive and the Machinery
Directive (commonly referred to as the MD) of the European Union.
Agilent has confirmed that each product complies with the relevant
Directives by testing a prototype against the prescribed EN (European
Norm) standards.
Proof that a product complies with these directives is indicated by the CE
symbol on the rear of the product, and the documentation that
accompanies the product containing a copy of the Declaration of
Conformity. The Declaration of Conformity (DoC) is the legal declaration
by Agilent that the product complies with the directives listed above, and
shows the EN standards to which the product was tested to demonstrate
compliance.
Environmental Conditions
This equipment meets the following IEC classifications:
• Pollution Degree 2 (See Note.)
• Installation Category II (See Note.)
• Equipment Class 1
NOTE
The "Pollution Degree" indicates the level to which a solid, liquid, or gas deteriorates
according to its dielectric strength. The "2" indicates a normal indoor atmosphere.
The "Installation Category" indicates the regulation for impulse withstand voltage and is
also known as the "Over Voltage Category". The "II" indicates electrical equipment.
To Next Page
Loading...
Need help?
General
