Agilent Technologies SPS 4 User Manual

60 Agilent SPS 4 Autosampler User’s Guide
5Maintenance
It is possible to adjust the tension on the pressure plate on a specific
channel (only if the wash pump can be turned on via the instrument
control software) using the following procedure. If necessary, adjust the
tension on the pressure plates following the instructions in “Pressure Plate
Adjustment” on Page 48.
Lubrication
The autosampler is self lubricating and does not need the user to apply
lubrication.
Service
An authorized Agilent customer support representative must perform all
servicing of the autosampler. For contact information, refer to the Agilent
Technologies website for your local representative’s contact details:
www.agilent.com
Spare Parts
For ordering information of the consumable spare parts, see the Agilent
website at www.agilent.com.
NOTE
Only use Agilent spare parts with your autosampler.
Table 6 Consumable spare parts
Description
Standard rack location mat
Spill tray
Tube anchor
Cable ducting

Agilent Technologies SPS 4 Specifications

General

Brand	Agilent Technologies
Model	SPS 4
Category	Laboratory Equipment
Language	English