Appendices A
Agilent SPS 4 Autosampler User’s Guide 89
Fitting the Side Covers
1 Fit the exhaust hose connection into the side cover with the hole by
rotating the end with the bayonet fitting clockwise as shown below.
2 Take the side cover with the exhaust hose connection fitted and fit to
the side of the autosampler that suits connection to an exhaust hose.
The side cover is pushed into the recesses of the end frame from the
inside and slides down to lock in place.
3 Fit the other side cover (blank) to the other end of the autosampler
using the same process.
To Next Page
Loading...
