VS Series Helium Mass Spectrometer Leak Detectors
DRAFT 4/23/15
xvii
WARNING The Wireless Remote complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that
may cause undesired operation.
To satisfy F C C R F exposure req u i r ements for mobile type transmit-
ting devices, maintain a separation distance of 20 cm or more
between the antenna of the Wireless Remote and persons during
operation, with exception of hands wrist, feet, and ankles. To
ensure compliance, operations at closer distance than this distance
are prohibited.
Maintain a separation distance of 20 cm or more between the oper-
ator and the RF antenna of the VS Series leak detector with a wire-
less base station.
CAUTION Use only approved type of antennas for:
❑ Wireless Remote: Centurion, Model WCP2400-MMCX2,
www.centurion.com.
❑ VS Series Leak Detector Wireless Base Station, Nearson,
Model S181FL-5-RMM- 2450S, www.nearson.com
Power and Static Sensitivity
WARNING Depending on the unit configuration ordered, the mains power
supply requirements for VS Series leak detectors are:
❑ 100 VAC, 50 Hz, 20 A
❑ 115 VAC, 60 Hz, 20 A or
❑ 230 VAC, 50/60 Hz, 12 A
Before powering the unit for the first time, verify that the unit is
configured to operate for the local mains supply voltage.
To Next Page
Loading...
