Agilent Technologies VS Series - Wireless

VS Series Helium Mass Spectrometer Leak Detectors
DRAFT 4/23/15
3-27
3.1.11 Wireless
When the wireless option is installed into the leak detector, a wireless icon button appears
on the second Setup screen (Menu/Setup/ Æ).
❑ Press the Wireless icon on the Setup screen and the wireless screen
appears (Figure 3-23).
Use this screen to assign the RF channel t
hat the remote handheld device uses for:
❑ Communications with the leak detector,
❑ Control of the leak detector
❑ And to get other information relating to wireless communications.
Figure 3-23 Wireless
MAC Address Two MAC addresses appear on this screen:
❑ The MAC address at the top of the screen is the leak detector
MAC address.
❑ The MAC address above the hand held button is the MAC
address of the hand held device.
SYNC Channel For informational and f
actory debug purposes only.
SS ID Displays the SS ID number, factory set to 086, for informational and
factory debug purposes only.
C
DONE
012345678910
MAC ADDRESS: 00:50:67:11:30:OC
SYNC CHANNEL: 007
SS ID: 086
DONE
DONE
CHANNEL
07
Opens a keypad
to configure the
channel for use.
✔
✕
Ends the session with the current wireless remote.
Any wireless is now free to establish communications
with the VS unit (
Buttononlyappearsifahandheld
00:50:67:10:2A:OD
Tu r ns all acces s to
the VS unit ON or
OFF.
unitisconnected).