VS Series Helium Mass Spectrometer Leak Detectors
DRAFT 4/23/15
2-27
To configure t h e l eak rate r a n g i n g :
1. Press the Range Stop blue check button.
2. Press the associated Range Stop Value button.
The data entry pad appears.
3. Enter the value and press OK to save the value.
4. Press the Manual Range blue check button.
5. Press the value button associated with the Test time.
The data entry pad appears.
6. Enter the value and press OK to save the value.
7. Press the High Pressure Test blue check button, if required.
To Next Page
Loading...
