control to adjust drone height
— —
self-inspection before operation
— —
start autonomous
operation at point AB
— —
click "end manual operation"
— —
pop-up window to check the
confirmation of operation effect——operation is over.
5.5.3.2. Adjust spray before working
After entering the AB operation, it will pop up automatically or click the top operation
parameter button before starting the operation to call up the spray setting pop-up window to
adjust the spray parameters.
Before starting work, you can set the spray mode, pump mode, working interval and flight speed.
Add A point
Click Add A to mark success. If you need to re-mark A at this time, you can click to delete
the marked A and re-mark A. After marking point A, the drone will start spraying according to the
set parameters. The spray area data before marking point B will be included in the manual work
area data and will be presented in the work effect confirmation after the work is completed.
Add B point
Click Add B to mark success. At this time, if you need to re-mark point B, you can click
to
delete the already marked point B, and then re-mark point B. At this time, if you need to add
point A again, you can click
the button twice in succession to delete point B and then delete
point A. After deletion, you need to add points A and B again.
5.5.3.3. Adjust the direction of the AB route
After the point B is completed, the route can be selected to pan left or right.
To Next Page
Loading...