File Management Commands
Page 178 7210 SAS M, T, X, R6 Basic System Configuration
uplinkA-vlan
Syntax uplinkA-vlan 0..4094
no uplinkA-vlan
Context bof
Description This command specifies a VLAN ID to be used on uplink-A.
The no form of the command is used to send untagged packets on uplink-A.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
________________________________________________________________________________
uplinkB-vlan
Syntax uplinkB-vlan 0..4094
no uplinkA-vlan
Context bof
Description This command specifies a VLAN ID to be used on uplink-B.
The no form of the command is used to send untagged packets on uplink-B.
________________________________________________________________________________
NOTE: This command is not supported on 7210 SAS-R6 platforms.
________________________________________________________________________________
eth-mgmt-address
Syntax [no] eth-mgmt-address ip-prefix\ip-prefix-length
Context bof
Description This command assigns an IP address to the management Ethernet port in the running configuration
and the Boot Option File (BOF). Deleting a BOF address entry is not allowed from a telnet session.
The no form of the command deletes the IP address assigned to the Ethernet port.
Default no eth-mgmt-address — There are no IP addresses assigned to the out-of-band Ethernet
management ports.
Parameters ip-prefix\ip-prefix-length — The IP address in dotted decimal notation.
Values ipv4-prefix a.b.c.d (host bits must be 0)
ipv6-prefix - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
To Next Page
Loading...
