File Management Commands
Page 180 7210 SAS M, T, X, R6 Basic System Configuration
eth-mgmt-route
Syntax [no] eth-mgmt-route ip-prefix/ip-prefix-length next-hop ip-address
Context bof
Description This command creates a static route entry for the management Ethernet port in the running
configuration and the Boot Option File (BOF).
This command allows manual configuration of static routing table entries. These static routes are
only used by traffic generated by the Ethernet port. To reduce configuration, manual address
aggregation should be applied where possible.
A static default (0.0.0.0 or 0) route cannot be configured on the management Ethernet port. A
maximum of ten static routes can be configured on the management Ethernet port.
The no form of the command deletes the static route.
Default No default routes are configured.
Parameters ip-prefix\ip-prefix-length — The destination address of the static route in dotted decimal notation.
100 — The destination address of the static route in dotted decimal notation.
Values ip-prefix|ip-prefix-length: ipv4-prefix a.b.c.d (host bits must be zero) ipv4-prefix-le
0 — 32
ipv6-prefix - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
Values Values mask — The subnet mask, expressed as an integer or in dotted decimal
notation. 0 — 32 (mask length), 128.0.0.0 — 255.255.255.255 (dotted decimal)
ipv6-prefix-length - 0 — 128
next-hop ip-address — The next hop IP address used to reach the destination.
Values ipv4-address - a.b.c.d
ipv6-address - x:x:x:x:x:x:x:x (eight 16-bit pieces)
x:x:x:x:x:x:d.d.d.d
x - [0..FFFF]H
d - [0..255]D
The destination address of the static route in dotted decimal notation.
eth-mgmt-speed
Syntax speed speed
Context bof
Description This command configures the speed for the management Ethernet port when Auto-negotiation is
disabled in the running configuration and the Boot Option File (BOF).
If the port is configured to Auto-negotiate, this parameter is ignored.
To Next Page
Loading...
Need help?
General
