Alcatel-Lucent 7210 SAS M - Page 190

Show Commands
Page 190 7210 SAS M, T, X, R6 Basic System Configuration Guide
uplinkA-vlan null
uplinkA-route 10.135.0.0/16 next-hop 10.135.25.1
uplinkA-route 135.254.0.0/16 next-hop 10.135.25.1
#uplinkB Port Settings:
uplinkB-port 1/1/24
uplinkB-address 0
uplinkB-vlan 0
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
no-service-ports 1/1/24 1/1/2
use-expansion-card-type m2-xfp
no console-disabled
===============================================================================
A:7210-SAS>show#
Sample output for 7210 SAS-M configured in Access uplink mode:
*A:7210-SAS-M>bof# show bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@135.254.170.22//tftpboot/apai/both.tim
primary-config ftp://*:*@10.135.5.171/./images/mtuUplink.cfg
primary-dns 135.254.246.204
#eth-mgmt Port Settings:
eth-mgmt-disabled
#uplinkA Port Settings:
uplinkA-port 1/1/24
uplinkA-address 10.135.5.179/24
uplinkA-vlan null
uplinkA-route 10.0.0.0/8 next-hop 10.135.5.1
uplinkA-route 10.135.0.0/16 next-hop 10.135.5.1
uplinkA-route 135.254.0.0/16 next-hop 10.135.5.1
#System Settings:
wait 3
persist off
console-speed 115200
uplink-mode access-uplink
no console-disabled
===============================================================================
*A:7210-SAS-M>bof#
Sample output for 7210 SAS-R6:
A:dut-a>show# bof
===============================================================================
BOF (Memory)
===============================================================================
primary-image ftp://*:*@192.168.87.201/./images/i386-cpm.tim
primary-config ftp://*:*@192.168.87.201/./images/dut-a.cfg
address 192.168.87.12/24 active
address 192.168.87.13/24 standby
static-route 135.250.124.0/24 next-hop 192.168.87.201
autonegotiate
duplex full