Date and Time Commands
Page 370 7210 SAS M, T, X, R6 Basic System Configuration
Guide
Syntax [no] minute {minute-number [..minute-number]| all}
Context config>cron>sched
Description This command specifies the minute to schedule a command. Multiple minutes of the hour can be
specified. When multiple minutes are configured, each of them will cause the schedule to occur. If a
minute is configured, but no hour or day is configured, the event will not execute. If a minute is
configured without configuring month, weekday, day-of-month, and hour, the event will not execute.
The no form of this command removes the specified minute from the configuration.
Parameters minute-number — Specifies the minute to schedule a command.
Values 0 — 59 (maximum 60 minute-numbers)
all — Specifies all minutes.
month
Syntax [no] month {month-number [..month-number]|month-name [..month-name]| all}
Context config>cron>sched
Description This command specifies the month when the event should be executed. Multiple months can be
specified. When multiple months are configured, each of them will cause the schedule to trigger. If a
month is configured without configuring weekday, day-of-month, hour and minute, the event will not
execute.
The no form of this command removes the specified month from the configuration.
Parameters month-number — Specifies a month number.
Values 1 —12 (maximum 12 month-numbers)
all — Specifies all months.
month-name — Specifies a month by name
Values january, february, march, april, may, june, july, august, september, october, novem-
ber, december (maximum 12 month names)
type
Syntax type {schedule-type}
Context config>cron>sched
Description This command specifies how the system should interpret the commands contained within the
schedule node.
Parameters schedule-type — Specify the type of schedule for the system to interpret the commands contained
within the schedule node.
To Next Page
Loading...
Need help?
General
