Alcatel-Lucent 7210 SAS M - Page 404

Redundancy Commands
Page 404 7210 SAS M, T, X, R6 Basic System Configuration
Guide
peer-name
Syntax peer-name name
no peer-name
Context config>redundancy>multi-chassis>peer
Description This command specifies a peer name.
Parameters name — The string may be up to 32 characters long. Any printable, seven-bit ASCII characters can be
used within the string. If the string contains special characters (#, $, spaces, etc.), the entire string
must be enclosed within double quotes.
source-address
Syntax source-address ip-address
no source-address
Context config>redundancy>multi-chassis>peer
Description This command specifies the source address used to communicate with the multi-chassis peer.
Parameters ip-address — Specifies the source address used to communicate with the multi-chassis peer.
sync
Syntax [no] sync
Context config>redundancy>multi-chassis>peer
Description This command enables the context to configure synchronization parameters.
igmp
Syntax [no] igmp
Context config>redundancy>multi-chassis>peer>sync
Description This command specifies whether IGMP protocol information should be synchronized with the multi-
chassis peer.
Default no igmp
igmp-snooping